Preparation - Sharp V-1 General & Electrics Manual

SHARP

4.5 PREPARATION

4.5.1 WARNINGS
1. Always use the recommended cutting tools. Otherwise this might cause an accident.
2. Do not use broken or defective cutting tools.
3. Ensure to have a sound lighting facility around the working area.
4. Tools and equipment surrounding the machine should be kept in place. Keep the
machine and working area clean and orderly.
5. Do not lay anything upon the working surfaces, including the guideways, saddle, safety
guards, etc.
4.5.2 NOTICES
1. Check the hydraulic oil level of the hydraulic tank regularly. Please use the
recommended oil as described in the oil guide table of the maintenance manual.
3. Use the standard cutting tools and tool length.
4. Always try a light-load machining before doing a heavy-load machining.
WARNING !!!
(a) Ensure the load capacity is correct before turning on the power supply.
(b) Ensure all the alarm messages of the alarm message indicator are off
before proceed.
V-1 KNEE MILL GENERAL MANUAL
CH4-5 KRDM24C0 V4.0S