Machine; Safety Equipment; Before Start-Up - Sharp V-1 General & Electrics Manual

SHARP

4.1 MACHINE

This machine could be only operated under manual or automatic mode( wihh control ).
The information about how to operate this machine is given below. Please read carefully
before starting to operate this machine.

4.2 SAFETY EQUIPMENT

1. Over-traveling limit switches for moving in the X, Y and Z directions.
2. Emergency stop push button
3. Another limit switch for option equipment.

4.3 BEFORE START-UP

Ensure all the wires and cables are insulated properly before starting up this machine,
otherwise might happen electric leakage and shock.
WARNING !!!
Ensure the load capacity is correct before turning on the power supply.
4.3.1 INSPECTION BEFORE TURNING ON THE POWER
1. Ensure you know how to use this machine before starting it.
2. Ensure the power supply of this machine is enough to run all the units of this machine
easily before starting up the machine.
3. Ensure there is no loose wiring or connector.
4. Ensure all the cable should be protected from contacting with chips, which might result
in an electric short.
5. Ensure all the oil levels are normal.
V-1 KNEE MILL GENERAL MANUAL
CH4-2 KRDM24C0 V4.0S