SHARP
3.5.2 ALIGNMENT OF HEAD
In order to get precision when machining, the head of machine perfectly square with table
is necessary. Use gauge to check the square within 0.02mm. Please check square of
machine following instructions:
1.
Loosen the binding bolts.(see the figure)
2.
Mount the gauge on the spindle nose and check the square within 0.02mm/300mm.
3.
Tight the bolts
4.
Check the precision again after tight all bolts.
V-1 KNEE MILL GENERAL MANUAL
CH3-13
KRDM24C0 V4.0S