Start And Stop The Machine - Sharp V-1 General & Electrics Manual

SHARP

4.4 START AND STOP THE MACHINE

4.4.1 START PROCEDURE
1. Connect the power supply.
2. To turn on the main power, the procedures below must be following:
Turn on the factory's main power supply ( Switch
Machine (optional) ( Release the EMERGENCY STOP button ( Press POWER ON
button.
WARNING !!!
Ensure the load capacity is correct before turning on the power supply.
4.4.2 EMERGENCY STOP PROCEDURE
If any emergency conditions are happened, push down the emergency stop button on the
operation panel to stop the machine immediately. Pull upward to release the emergency stop
button.
4.4.3 NORMAL STOP PROCEDURE
1. Push the "EMERGENCY STOP" button of NC equipment.
2. Turn off the main power supply switch.
V-1 KNEE MILL GENERAL MANUAL
ON the main power switch of the
CH4-4 KRDM24C0 V4.0S