Sharp V-1 General & Electrics Manual page 10

SHARP
CHAPTER 8 APPENDIX
8.1 TROUBLE SHOOTING ...................................................................................... CH8-2
8.2 ISO METRIC THREAD DATA ........................................................................... CH8-6
8.3 CUTTING SPEED .............................................................................................. CH8-6
8.4 CUTTING DEPTH .............................................................................................. CH8-8
8.5 FEED SPEED .................................................................................................... CH8-8
CHAPTER 9 PARTS LIST
9.1 HEAD DRAWING .............................................................................................. H01-1
9.2 VERTICAL MILLING HEAD DRAWING ............................................................ H02-1
9.3 UP-DOWN & LEFT-RIGHT DRAWING ............................................................. H03-1
9.4 FRONT- REAR DRAWING ................................................................................ H04-1
CHAPTER 10 ELECTRICS DRAWINGS
V-1 KNEE MILL GENERAL MANUAL
9 KRDM24C0 V4.0S