LOWR
8. Install the dowels m, cover n, and then
tighten the cover bolts o to the specified
torque.
o
n
m
Cover bolt o:
8 N·m (0.8 kgf·m, 5.9 ft·lb)
9. Install the rubber seals p and water pipe
q.
Installing the shift rod
Do not reuse an oil seal or O-ring, always
replace it with a new one.
8-31
Lower unit
p
q
1. Install a new O-ring a and a new oil seal
b to the plate c.
2. Install the plate c to the shift rod d.
c
3. Install the shift rod d.
a
90°
b
TIP:
Turn the shift rod d clockwise 90°, and then
push it down so that the tip a of the shift rod
d fits into the groove b in the shift slider.
Installing the water pump
Do not reuse a gasket or O-ring, always
replace it with a new one.
b
c
a
d
d
a