Rigging Grommet Mounting; Rigging Grommet Description; Installing The Main Harness - Yamaha F225F Service Manual

5. Apply sealant to the mounting holes and
secure the outboard motor using the
included mounting
washers c, large washers d, and nuts
e. NOTICE: Make sure that there is
no clearance between the surfaces of
the boat transom and the clamp
brackets. Otherwise,
brackets or boat transom may be
damaged.
b
c
e
d
c
b
Boat transom
thickness (D)
65–75 mm
(2.56–2.95 in)
75–95 mm
(2.95–3.74 in)
TIP:
The second hole from the top of each clamp
bracket is recommended for the upper
mounting bolt.
6. Install the mounting bolts, and then
tighten the nuts firmly. NOTICE: Make
sure that the clamp brackets do not
bite into the boat transom.
7. Tighten the locknuts firmly.
Outboard motor mounting / Rigging grommet mounting
b,
bolts small
the clamp
b
c
d
c
e
c
d
c
e
Mounting bolt
M12 × 130 mm
(5.12 in)
M12 × 150 mm
(5.91 in)

Rigging grommet mounting

Rigging grommet mounting

Rigging grommet description

c
b
a
a Battery cable
b Isolator lead (optional)
c Extension wiring harness
d Fuel hose
e Flushing hose

Installing the main harness

1. Remove the grommet holder a and rig-
ging grommet b.
b
2. Remove the plastic tie c that is fastening
the main wiring harness coupler a.
d
e
a
3-8
0
1
2
3
4
5
6
7
8
9
10
A