Yamaha F225F Service Manual page 98

RIG
GING
TIP:
• Make sure that the distance g is equal to
distance h.
• If the boat has a V shape hull, the center
outboard motor should have longer transom
height than the outboard motors on both
sides.
• For the distance (T1), see "Dimension" (3-
2).
2. Adjust the position of the outboard motor
so that the height of the anti-cavitation
plate k is equal to or slightly above the
bottom of the boat transom.
A
B
k
C
k
A Single outboard motor
B Twin outboard motor
C Triple outboard motor
3-7
Rigging information
k
k
k
k
TIP:
This mounting height information is for refer-
ence only. It is impossible to provide com-
plete instructions for every possible boat and
outboard motor combination.
3. Adjust the height of the scale m to the
transom height (H), and place it on the
special service tool a. Secure the
special service tool a to the boat
transom using screws or vises.
TIP:
For the transom height (H), see "Dimension"
(3-2).
4. When the outboard motor mounting
position has been determined, mark the
best-suited 4
holes in the boat transom n. Drill the
mounting holes perpendicular to the
surface of the boat transom using a
13.0 mm (0.5 in) drill bit.
m
n
p
C/L: Centerline of transom
Drilling plate a: 90890-06783
Mounting hole diameter p:
13.0 mm (0.5 in) or more
symmetrical mounting
a
H
m
C/L