Yamaha F225F Service Manual page 508

BRKT
t
s
t
o
t
p
Self-locking nut o:
23 N·m (2.3 kgf·m, 17.0 ft·lb)
Grease nipple t:
3 N·m (0.3 kgf·m, 2.2 ft·lb)
12. Inject grease into the grease nipples until
grease comes out from the bushings e.
9-29
Bracket unit
t
t
r
d
n
q
e
Adjusting the trim sensor
After tilting the swivel bracket up, make
sure to support it using the tilt stop lever.
Otherwise, the swivel bracket could sud-
denly lower.
1. Fully tilt the swivel bracket up, and then
n
support it using the tilt stop lever a.
a
2. Loosen the trim sensor screws b.
3. Adjust the position of trim sensor, and
then tighten the trim sensor screws b
temporarily.
TIP:
• To decrease the resistance, turn the trim
sensor cam in direction a.
• To increase the resistance, turn the trim
sensor cam in direction b.
4. Fully tilt the swivel bracket down.
5. Measure
resistance. Check that the resistance is
within specification.
b
b
the trim sensor
a
setting