Installing The Low-Pressure Fuel Pump - Yamaha F225F Service Manual

FUEL
b
a
Leakage tester a: 90890-06840
Specified positive pressure:
170.0 kPa (1.70 kgf/cm
Installing the low-pressure fuel
pump
1. Install the clamps a temporarily onto the
fuel hose b.
2. Connect the fuel hose b to the low-
pressure fuel pump c and joint d, and
then fasten the fuel hose b using the
clamp a.
3. Install the low-pressure fuel pump c and
cover e, and then tighten the pump
cover bolts f to the specified torque.
b
Pump cover bolt f:
5 N·m (0.5 kgf·m, 3.7 ft·lb)
4. Install the clamps g temporarily onto the
fuel hose h.
5. Connect the fuel hose h, and then
fasten it using the clamps g.
6-31
Fuel system
a
2
, 24.7 psi)
e
c
d
a
a
6. Install the fuel hose h to the holders i
and j.
j
i
c
7. Install the clamp k temporarily onto the
fuel hose l.
8. Connect the fuel hose l, and then
fasten it using the clamp k.
9. Connect the fuel hose m to the joint and
fasten the fuel hose using the plastic tie
n, and then install the fuel hose to the
holder o.
10. Connect the low-pressure fuel pump
coupler a.
f
f
g
m
l
k
o n
a
h