Yamaha F225F Service Manual page 496

BRKT
Needle bearing attachment b:
90890-06611
Driver rod L3 c: 90890-06652
2. Install the circlip d.
d
3. Install the rubber seal e into the upper
case.
e
4. Insert the tip of the water pipe f into the
rubber seal e, install a new rubber seal
g, the rubber seal h, the dowels i, and
the oil pan assembly a, and then tighten
the upper case bolts j and k to the
specified torque.
5. Install the anodes l, and then tighten
the anode screws m to the specified
torque.
9-17
Bracket unit
k
i
e
Upper case bolt j (M10):
42 N·m (4.2 kgf·m, 31.0 ft·lb)
Upper case bolt k (M8):
20 N·m (2.0 kgf·m, 14.8 ft·lb)
Anode screw m:
4 N·m (0.4 kgf·m, 3.0 ft·lb)
6. Install the damper n, the cover o, and a
new gasket p, and then tighten the drain
bolt q to the specified torque.
n
o
p
q
Drain bolt q:
27 N·m (2.7 kgf·m, 19.9 ft·lb)
m
j
m l
j
l
k
a
f
h
g