Assembling The Reverse Gear; Assembling The Propeller Shaft Housing Assembly - Yamaha F225F Service Manual

LOWR
TIP:
When installing the slider c, make sure that
the balls b do not fall out of position.
2. Install the dog clutch d so that the hole
a in the dog clutch d and the hole b in
the propeller shaft are aligned with the
hole c in the slider c.
a
d
a
d
3. Install the cross pin e, and then install
the spring f.
e
f

Assembling the reverse gear

1. Install the thrust washer a and a new
ball bearing b. NOTICE: Do not reuse
a bearing, always replace it with a new
one.
8-19
Lower unit
b
c
b c
f
e
c
b
a
Bearing inner race attachment c:
90890-06661
Assembling the propeller shaft
housing assembly
• Use heat-resistant gloves. Otherwise,
burns could result.
• To prevent fires, remove any flammable
substances, such as gasoline and oil,
around the working area.
• Keep good ventilation while working.
Do not reuse a bearing, oil seal, or O-ring,
always replace it with a new one.
1. Heat the installation area of the taper
roller bearing outer race in the propeller
shaft housing a using a gas torch, and
then install a new taper roller bearing
outer race a. NOTICE: When heating
the propeller shaft housing, heat the
entire installation area evenly. Other-
wise, the propeller shaft housing
could be damaged.
c
b
a
a
a