Assembling The Lower Case; Assembling The Oil Seal Housing; Install The Reverse Gear; Installing The Drive Shaft - Yamaha F225F Service Manual

LOWR
b
c
b
Needle bearing attachment b:
90890-06653
Driver rod L3 c: 90890-06652
Installation depth a:
9.2–9.6 mm (0.36–0.38 in)
TIP:
Face the bearing identification mark b on the
needle bearing a up.
3. Install the circlip d.

Assembling the lower case

See "Assembling the lower case" (8-27).

Assembling the oil seal housing

See "Assembling the oil seal housing" (8-28).

Install the reverse gear

1. Install the adapter a, original reverse
gear shim b, thrust bearing c, and
reverse gear d.
8-79
Lower unit
c
b
a
d
a
e
TIP:
Make sure to fit the dowel e into the slot a
in the lower case.

Installing the drive shaft

See "Installing the drive shaft" (8-28).
Installing the propeller shaft housing
assembly
Do not reuse a bearing or O-ring, always
replace it with a new one.
1. Install a new O-ring a.
2. Install the original forward gear shims b,
propeller shaft housing c, and key d.
b
d
c
b
a
d
a
c
a