Installing The Digital Electronic Control Box And Switch Panel; Installing Y-Cop (Optional In Non-European Markets); Registering The Receiver Id To The Ecm - Yamaha F225F Service Manual

Optional equipment / Installing the Digital Electronic Control box and switch panel /
6. Connect the speed sensor coupler b.
7. Connect the extension hose b to the
speed sensor adapter f.
8. Fasten the extension hose b using the
plastic tie g.
Installing the Digital Electronic
Control box and switch panel
For the installation procedures, see the Digi-
tal network control service manual.

Installing the Digital Electronic Control box and switch panel

Installing Y-COP (optional in non-European markets)

Installing Y-COP (optional in
non-European markets)
See the Yamaha Security System Y-COP
installation manual.
f
• Install the receiver so that the UP mark
is facing up.
• Do not install the receiver in a location
where it will be exposed to water.
• Do not cover the receiver with metal
objects. Otherwise, signals may not be
received.
b
1. Install the receiver a, and then tighten
f
b
Receiver screw b:
TIP:
• Mount the receiver within 3 m (10 ft) from
the steering position.
• For installation position and drill holes, see
g
Yamaha Security System Y-COP installa-
tion manual.
2. Connect the Y-COP wires. See "Digital
b
Registering the receiver ID to the
ECM
1. Check that the engine start switch is
the receiver screws b to the specified
torque.
a
a
4 N·m (0.4 kgf·m, 3.0 ft·lb)
network system diagram" (3-21).
OFF.
0
1
2
3
4
b
5
6
b
7
8
9
10
A
3-12