Installing The Water Pump And Shift Rod - Yamaha E115A Service Manual

NOTE:
9 To secure the ring nut, bend one tab q of
the claw washer into a slot in the ring nut.
9 Bend all other tabs toward the propeller
shaft housing assembly.
Ring nut wrench 3 9:
90890-06511
Ring nut wrench extension 0:
90890-06513
Ring nut 8:
103 N·m (10.3 kgf·m, 76.0 ft·lb)
Installing the water pump and shift
rod
1. Install the shift rod assembly 1.
1
NOTE:
9 Check the gear shift to the neutral position,
when installing the shift rod.
9 After assembling the lower unit, check that
the shift rod operates smoothly, and check
that the drive shaft and propeller shaft
rotates smoothly.
61U5H11
q
6F600065
6G460200
Drive shaft and lower case
2. Install a new gasket 2, the outer plate
cartridge 3, and dowels 4.
3
2
4 4
3. Install the Woodruff key 5 into the drive
shaft.
4. Align the groove in the impeller 6 with
the Woodruff key 5, and then install the
impeller onto the drive shaft.
5. Install the washers 7, wave washer 8,
spacer 9, and collar 0 onto the drive
shaft.
NOTE:
9 The collar and spacer should fit together
firmly.
9 While pulling the drive shaft up, install the
collar with an appropriate tool a that fits
over the drive shaft as shown.
1
2
3
4
6G460210
5
6
6
5
7
69D60235
8
9
6-18