Store Current Configuration To The As-I Master - Pepperl+Fuchs VBG-EN-K20-D Manual

Byte 12
Result: See chapter 8.2.1 "Values for results"
Byte 1
Byte 2
Byte 3
Byte 4
Byte 5
Byte 6
Byte 7
Byte 8
Byte 9
Byte 10
Byte 11
Byte 12
To get the input data again, the T-bit has to be reset again.
8.5.2

Store current configuration to the AS-i master

1. Switch master to configuration mode
2. Write the current slave configuration to the master
3. Switch master to protected mode
4. Wait until master is in normal (protected) operation mode
12-byte management
1. Switch master to config mode
Byte 1
Byte 2
Byte 3
Byte 4
...
Byte 12
Byte 1
Byte 2
...
Byte 12
Subject to reasonable modifications due to technical advances.
110
Pepperl+Fuchs Group · Tel.: Germany (6 21) 7 76-0 · USA (3 30) 4 25 35 55 · Singapore 7 79 90 91 · Internet http://www.pepperl-fuchs.com
Request
00
hex
Response
50
hex
80 (toggle bit, master1)
hex
16-bit channel 1 high byte
16-bit channel 1 low byte
16-bit channel 2 high byte
16-bit channel 2 low byte
16-bit channel 3 high byte
16-bit channel 3 low byte
16-bit channel 4 high byte
16-bit channel 4 low byte
00 not used
hex
00 not used
hex
Request: SET_OP_MODE
0C (SET_OP_MODE)
hex
00 (T = 0, master 1, single master)
hex
01 (= config mode)
hex
00
hex
...
00
hex
Response
00 (or old values)
hex
00 (or old values)
hex
...
00 (or old values)
hex
Command Interface
hex
hex
hex
hex
hex
hex
hex
hex
AS-Interface
Copyright Pepperl+Fuchs, Printed in Germany