Table of Contents
Advertisement
byte
1
2
3
4
Meaning of bit B:
B = 0Single AS-i slave or A-slave
B = 1B-slave
8.3.5.5
Set permanent configuration (SET_PCD)
This call sets the following configuration data for the addressed AS-i slave:
• I/O configuration
• ID code
• Extended ID1 code
• Extended ID2 code
The configuration data are stored permanently on the EEPROM of the AS-i/Ether-
Net/IP gateway and are used as the expected configuration by the AS-i master in
the protected mode. The configuration data are specified by the manufacturer of
the AS-i slave.
If the addressed AS-i slave does not support an extended ID code 1/2, the value
F
must be specified.
hex
When this command is executed, the AS-i master changes to the offline phase and
then changes back to the normal mode (warm restart).
This command can only be executed in the configuration mode.
byte
1
2
3
4
5
byte
1
2
Meaning of bit B:
B = 0Single AS-i slave or A-slave
B = 1B-slave
Subject to reasonable modifications due to technical advances.
Pepperl+Fuchs Group · Tel.: Germany (6 21) 7 76-0 · USA (3 30) 4 25 35 55 · Singapore 7 79 90 91 · Internet http://www.pepperl-fuchs.com
7
6
5
2
2
2
T
xID2
ID
7
6
5
2
2
2
T
–
–
B
xID2
ID
7
6
5
2
2
2
T
AS-i EtherNet/IP Gateway
Command Interface
Response
4
3
2
2
28
16
result
Request
4
3
2
2
25
16
circuit
slave address
Response
4
3
2
2
25
16
result
Copyright Pepperl+Fuchs, Printed in Germany
2
1
0
2
2
2
xID1
I0
2
1
0
2
2
2
xID1
I0
2
1
0
2
2
2
83
Advertisement
Table of Contents
