Setting Up The As-I Bus - Pepperl+Fuchs AS-i Compact Manual

Ethernet/ip + modbus tcp gateways

Hide thumbs Also See for AS-i:

Table of Contents

EtherNet/IP + Modbus TCP-Gateways

Setting up the AS-i bus

Connect the unit to power.

Connect the AS-i cable to the unit.

One after the other connect the AS-i slaves to the AS-i cable and set the

slave addresses. 

You may set the addresses directly on the slave using a portable addresser

or by using the option [SLAVE ADR TOOL] in the display menu of your

gateway.

In the display menu select [QUICK SETUP] to use the configuration of all

AS-i circuits connected to the unit.

Confirm with [STORE+RUN].

Set the ModbusTCP address and connect the gateway to the host fieldbus

controller. 

You can set the addresses directly using the option [MODBUSTCP] in the

display menu of your gateway or through the PC using the ASIMON soft-

ware with integrated AS-i Control Tools.

The address can also be set by the host controller.

For more detailed information please refer to the installation guide for your gateway

which is included with the unit.

Table of Contents