Table of Contents
Advertisement
1. Following commands are supported:
1: S-7.4 ID string Read (no sent data required).
2: S-7.4 Diag String Read (no sent data required).
3: S-7.4 Param String Read (no sent data required).
4: S-7.4 Param String Write (buffer contains sent string).
5: S-7.5 Transfer. Buffer contains sent string in the same form, as the telegram,
that have to be sent over AS-i.
6: S-7.5 Cyclic 16-Bit Slave Configuration Read (analog/transparent bits are
cancelled in the response). The cyclic 16-bit configuration cannot be detected,
if the response is 08h.
7: Safety Monitor sorted Read (no sent data required).
8: Safety Monitor unsorted (all devices) Read (no sent data required).
Please view <chapter 8.4.2 Monitor Diagnosis> for further information.
Byte
1
2
Subject to reasonable modifications due to technical advances.
Pepperl+Fuchs Group · Tel.: Germany (6 21) 7 76-0 · USA (3 30) 4 25 35 55 · Singapore 7 79 90 91 · Internet http://www.pepperl-fuchs.com
7
6
5
2
2
2
AS-i EtherNet/IP Gateway
Command Interface
Response
4
3
2
2
4E
16
response
Copyright Pepperl+Fuchs, Printed in Germany
2
1
0
2
2
2
67
Advertisement
Table of Contents
