Table of Contents
Advertisement
In the classical mode, it is possible to change settings while the device is in
operation. This can lead to failure of the plant (e. g. changing the address of
an AS-i slave).
In the advanced mode, however, the settings are protected, as long as the supe-
rior fieldbus is running.
The device starts in the classical mode (see chapter 7). Press ESC to switch to the
extended mode.
In the extended mode, the selection can be moved up and down with the arrow
buttons.
Pressing OK will switch to the selected function or menu. Pressing ESC will switch
back to the previous menu.
To edit data values highlight them with the selection bar, press OK, then change
them with the arrow-buttons and confirm with OK. The ESC-button cancels the
editing process.
All possible addresses are displayed one after the other from 1A to 31A and from
1B to 31B. Data for single slaves are displayed at the addresses 1A - 31A.
Subject to reasonable modifications due to technical advances.
Pepperl+Fuchs Group · Tel.: Germany (6 21) 7 76-0 · USA (3 30) 4 25 35 55 · Singapore 7 79 90 91 · Internet http://www.pepperl-fuchs.com
Operating in Advanced Display Mode
E T H E R N E T / I P
Q U I C K S E T U P
S L AV E A D D R T O O L
1.12 A
S L AV E T E S T T O O L
S E T U P
I O + PA R A M . T E S T
D I A G N O S I S
A D V. D I A G N O S I S
A S - I S A F E T Y
L A N G U A G E
D I S P L AY C O N T R A S T
AS-i EtherNet/IP Gateway
Copyright Pepperl+Fuchs, Printed in Germany
29
Advertisement
Table of Contents
