Store Current Configuration To The As-I Master - Pepperl+Fuchs VBG-PB-K25 Manual

8.3.2

Store current Configuration to the AS-i Master

1. Switch master to configuration mode
2. Write the current slave configuration to the master
3. Switch master to protected mode
4. Wait until master is in normal (protected) operation mode
12 Byte Management
1. Switch master to config mode
Byte 1
Byte 2
Byte 3
Byte 4
...
Byte 12 00
Byte 1
Byte 2
...
Byte 12 00
No result because toggle bit = 0.
Set the Toggle Bit:
Byte 1
Byte 2
Byte 3
Byte 4
...
Byte 12 00
Byte 1
Byte 2
Byte 3
...
Byte 12 00
Master is now in configuration mode.
Subject to reasonable modifications due to technical advances.
78
Pepperl+Fuchs Group · Tel.: Germany (6 21) 7 76-0 · USA (3 30) 4 25 35 55 · Singapore 7 79 90 91 · Internet http://www.pepperl-fuchs.com
Request: SET_OP_MODE
0C (SET_OP_MODE)
hex
00 (T = 0, master 1, single master)
hex
01 (= config mode)
hex
00
hex
...
hex
Response
00 (or old values)
hex
00 (or old values)
hex
...
(or old values)
hex
Request: SET_OP_MODE
0C (SET_OP_MODE)
hex
80 (T = 1, master 1, single master)
hex
01 (= config mode)
hex
00
hex
...
hex
Response
0C
hex
80 (T = 1, result = 0)
hex
00 (or old values)
hex
...
(or old values)
hex
AS-Interface
Command Interface
Copyright Pepperl+Fuchs, Printed in Germany