Optional: Using Wall Holders; Optional: Use Of Cable Protectors - Otto Bock 743L500 3D L.A.S.A.R. Posture Instructions For Use Manual

Preparing the product for use

4.5 Optional: Using wall holders

~1200 mm
~90°
743Y725
~1050 mm

4.6 Optional: Use of cable protectors

78
~1200 mm
Instead of the standard setup for the camera stands in
the holders of the upper and lower case sections, the
upper sections of the camera stands may be installed in
the 743Y725 wall holders.
The screws and dowels are not included in the scope of
delivery since they have to be chosen according to the
properties of the walls.
► Optionally the plate with the mini-computer can be
removed from the lower section of the case and set
up in a suitable location.
► NOTICE! The wall holders have to be positioned
on the walls so that the height of the camera
stands can be adjusted and the wall holders do
not interfere with the view angle of the camer­
as.
INFORMATION: For easier determination of the
wall holder positions on the walls, initially
using the setup with the upper and lower case
sections is recommended in order to gain prac­
tical experience with the alignment of the cam­
era stands relative to the force measurement
plate. The holders can be moved in the rails so
that subsequent alignment of the camera
stands is possible (for example after rotating
the force measurement plate).
Install the wall holders on the walls according to the
illustration.
► Push the camera stands into the wall holders.
Optional cable protectors can be used to reduce the
risk of tripping and damaging the cables.
The cable protectors are not included in the scope of
delivery and can be obtained from specialist dealers.
► Position the cable protectors over the cables as
shown.
743L500 3D L.A.S.A.R. Posture