Optional: Installing The Foam Cover; Cockpit App; System Requirements; Initial Connection Between Cockpit App And Component - Otto Bock C-Leg 3C98-3 Instructions For Use Manual

Cockpit app

7.2 Optional: Installing the foam cover

If a cosmetic foam cover is installed on the knee joint, the charging receptacle has to be moved with the following
charging cable extensions:
• 4X156-1 Charger Extension Cable – Ankle
• 4X158-1 charger extension cable – ankle, long
• 4X157-1 Charger Extension Cable – Knee
Further information on the installation and use of the charging cable extensions is found in the instructions for use
included with the charging cable extensions.
8 Cockpit app
The cockpit app enables switching from basic mode into the pre-configured MyModes. In
addition, information about the product (step counter, battery charge level, etc.) can be
called up.
The behaviour of the product can be changed to a certain extent on a day-to-day basis
using the app (e.g. while becoming accustomed to the product). The adjustment software
can be used to trace the change at the patient's next appointment.
Information on the Cockpit app
• The Cockpit app can be downloaded free of charge from the respective online store. For more information,
please visit the following website: https://www.ottobock.com/cockpitapp. To download the Cockpit app, the
QR code on the supplied Bluetooth PIN card can also be read with the mobile device (requirement: QR code
reader and camera).
• The language of the user interface in the Cockpit app can be changed using the adjustment software.
• Depending on the version of the Cockpit app being used, the language of the user interface in the Cockpit app
corresponds to the language of the mobile device on which the Cockpit app is being used.
• The serial number of the component to be connected has to be registered with Ottobock the first time it is con­
nected. If the registration is not accepted, use of the Cockpit app for this component will be limited.
• Bluetooth on the prosthesis must be turned on in order to use the Cockpit app.
If Bluetooth is switched off, it can be turned on by turning the prosthesis upside-down (sole of the foot must
point up) or by connecting/disconnecting the battery charger. Bluetooth is then turned on for approx.
2 minutes. During this time, the app must be started and used to establish a connection. If required, Bluetooth
on the prosthesis can be switched on permanently afterwards (see page 41).
• The illustrations in these instructions for use are only examples and may deviate from the respective mobile
device being used and the version.
• Keep the mobile app up to date at all times.
• Please contact the manufacturer if you suspect cybersecurity problems.

8.1 System Requirements

See the information in the Apple App Store or Google Play Store regarding compatibility with mobile devices and
versions.

8.2 Initial connection between cockpit app and component

The following points need to be observed before establishing the connection:
• Bluetooth of the component must be switched on (see page 41).
• Bluetooth on the mobile device must be switched on.
• The mobile device must not be in "flight mode" (offline mode), otherwise all wireless connections are turned
off.
• The mobile device must be connected to the Internet.
• The serial number and Bluetooth PIN of the component being connected must be known. They are found on
the enclosed Bluetooth PIN card. The serial number begins with the letters "SN".
INFORMATION
If the Bluetooth PIN card with the Bluetooth PIN and serial number of the component is lost, the Bluetooth PIN
can be determined using the adjustment software.
32 C-Leg 3C98-3/3C88-3