Sercos Address - LinMot C1250-IP Series Application Note

10.2.3 Sercos Address

The sercos address is set via the two ID-switches S1 and S2, where S1 sets the high digit and S2 the low digit.
The address can have a value between 1 (01h) and 255 (FFh).
Set the sercos address by S1 & S2
Note:
The sercos address has no use with some identification modes like topology-based addressing.
If both address selectors are set to 0, the topology address is used as the sercos address when
topology-based addressing is configured in the PLC.
Page 122 of 205
PLC Commissioning
NTI AG / LinMot