8.4 Disassembly and Replacement
8.4.1
Manual feed unit (roller)
(1) Remove the upper feed cover and left feed
cover.
(2) Remove the screw, bracket in the front side and
link arm fixing stop ring in the rear side, and
then take out the manual feed tray unit.
(3) Disconnect the connector of the electromag-
netic clutch and sensor.
(4) Remove the stop ring on the hinge shaft on the
front side.
(5) Remove the manual feed unit from the hinge
shaft on the front side while sliding it towards
the rear side.
4560/4570 FEEDER
Bracket
8 - 8
Link arm
Stop ring
Manual feed tray unit
Connector
Stop ring
Nov. 1997 © TOSHIBA