Toshiba 4560 Service Manual page 322

18.13.2 Transport belt
(1) Remove the transport unit.
(2) Loosen the two screws (front and rear) holding
the belt tension plate.
(3) Rotate the belt tension plate toward you to
loosen the transport belt.
(4) Remove the transport belt.
Note: During reassembly, the edge of the trans-
port belt should be inside the side frame of
the transport unit. After reassembly, check
that the belt is not deviated to one side
(should be on the center.)
4560/4570 RADF
Rear side
Front side
Frame
18 - 64
Belt tension plate
Transport belt
Belt tension plate
Transport belt
Nov. 1997 © TOSHIBA
Frame