Toshiba 4560 Service Manual page 167

12.5.8 Lower exit roller
(1) Remove the fuser unit.
(2) Remove the pressure roller separation claw unit
(2 screws). Refer to 12.5.4(3).
Note: Attach the stop-ring as shown in the figure
below.
Stop-ring
12.5.9 Pressure roller separation claw
(1) Remove the pressure roller separation claw unit
(4 screws).Refer to 12.5.4.
(2) Remove the spring and the pressure roller
separation claw.
(3) There are 5 separation claws in all. Remove
them as described in (2).
12.5.10 Fuser entrance paper guide
(1) Remove the fuser cover (2 screws).
(2) Remove the bracket (2 screws).
Note: Be careful not to damage the mylar sheets
sticked on the bracket.
Nov. 1997 © TOSHIBA
Handle
Separation claw
12 - 13
Lower exit roller
Stop-ring
Spring
4560/4570 FUSER