Toshiba 4560 Service Manual page 108

[A] Manual feed roller
(1) Remove the sensor bracket screws and pick
up the bracket.
(2) Remove the stop ring. Pull out the feed roller in
the direction of the arrow A.
[B] Pick-up roller
(1) Remove the stop-ring.
(2) Pull out the ø6 shaft in the direction of the ar-
row B.
Notes: Pay attention to the following points when
reassembling the manual, pick-up, feed and
separation rollers.
1. Set the timing belt securely on the pul-
ley.
2. Be careful not to mistake the setting po-
sition of the timing belt (manual feed
roller).
3. Put the clip properly into the slot of the
shaft.
4. Check that no oil etc. has adhered to the
surface of the timing belts, pulleys and
rollers.
5. Make sure of the roller orientation.
Paper
Separation pad
Nov. 1997 © TOSHIBA
Paper feed roller
Pick-up roller
8 - 9
Sensor bracket
Pick-up roller
Stop ring
B
A
Stop ring
Feed roller
4560/4570 FEEDER