Toshiba 4560 Service Manual page 119

9.4 Disassembly/Replacement
Remove the switch cover and the process unit as required to create easy-to-service conditions.
9.4.1 Process unit
[A] Remove the process unit
(1) Remove the toner cartridge.
(2) Lift up the upper unit.
(3) Remove the connector cover (1 screw) (for Eu-
ropean machines).
(4) Remove the one screw shown by the arrow.
Pull out the unit to the front side.
Notes: 1. Be careful not to damage the drum.
2. Check that the drum shaft is in the
cleaner unit.
[B] Disassembly and reassembly of cleaner section and developer unit
(1) Place the process unit on the flat space. Pull up the front side and rear side lever in the cleaner
section. Disconnect the developer unit from the cleaner section.
Notes: 1. Be careful not to damage the drum.
2. Check that the drum shaft is in the cleaner unit.
Front side lever
[Front side]
Nov. 1997 © TOSHIBA 9 - 5
Rear side lever
[Rear side]
4560/4570 DRUM