Toshiba 4560 Service Manual page 113

Note: If the LCF has been installed on the copier,
use the following procedure to remove the
harness cover and the connector.
1. Remove the right feed cover.
2. Remove the hinge stopper for the LCF
in order to open it fully.
3. Open the LCF fully.
4. Remove the harness cover.
5. Disconnect the connector from the feed
unit.
[A] Cassette feed unit (rollers)
(1) Remove the clutch bracket.
(2) Remove the separation roller holder (2 screws).
(3) Remove the pick-up roller from the arm.
(4) Slide the feed roller in the direction of the ar-
row A and pull out the bush from the shaft.
(5) Remove the stop-ring and pick-up arm from the
shaft and pull out the feed roller.
4560/4570 FEEDER
LCF
Right feed cover
Pick-up arm
Stop-ring
Separation
Bush
Pick-up roller
Cassette feed unit
8 - 14
Hinge stopper
Clutch bracket
One-way clutch
Feed roller
(CLUTCH-6-L)
roller
One-way clutch
(CLUTCH-6-R)
Nov. 1997 © TOSHIBA
Clutch
bracket