Toshiba 4560 Service Manual page 163

(6) Pull the heater lamp out towards the front side.
Notes: 1. Do not touch the heater lamp surface di-
rectly with your hands.
2. Set the TOSHIBA mark facing the front
side.
12.5.3 Heat roller
(1) Remove the heater lamp.
(2) Remove the separation claw unit (2 screws
each, golden).
(3) Remove the pressure bracket. (2 screws).
(4) Lift up the cleaning felt roller and cleaning roller
to remove them.
(5) Remove the support bracket (2 screws).
(6) Remove the bracket fixing the thermistor and
thermostat (2 screws).
Note: Be careful not to deform the root of the ther-
mistor harness when removing the bracket.
(7) Remove the stay bracket (2 screws).
(8) Remove the C-ring at the front and rear side,
and the gear at the rear side.
(9) Release the pressure (2 screws).
(10)Remove the ball bearing from the frame.
Nov. 1997 © TOSHIBA
Pressure bracket
Gear
12 - 9
C-ring
[Rear side]
4560/4570 FUSER