Toshiba 4560 Service Manual page 323

18.13.3 Belt holding roller/brush
(1) Remove the transport belt.
Belt holding roller
(1) Replace the belt holding roller on the feed side
after removing the rubber roller on the feed side.
The belt holding roller on the exit side should
be replaced by having the belt tension plate
inclined. (There is no need to remove the rub-
ber roller.)
Note: During the replacement of the belt hold-
ing roller, never remove the side frame
of the transport unit. (Do not remove the
screws which are fastening the side
frame except when replacing the side
frame.)
Brush
(1) Remove two screws and take out the brush
holding bracket.
18.13.4 Original feed tray
(1) Remove two M4 screws and take out the tray
in an upward direction.
Nov. 1997 © TOSHIBA
Belt holding rollers
(Feed side)
Rubber roller
18 - 65
Rubber roller
Belt holding rollers
(Exit side)
Brush
Original
feed tray
4560/4570 RADF