Toshiba 4560 Service Manual page 38

A-2) BYPASS MISFEED (
• During sheet bypass copying
The manual feed clutch (CLT4) has been turned ON
The paper-stop switch-1 (S7) comes ON
* If the paper-stop switch-1 (S7) does not come ON within the specified time:
BYPASS MISFEED
The BYPASS MISFEED symbol is displayed
Copying cannot be started
Clearing method:
A-3) INSERT KEY COPY COUNTER (
• If the copy counter (optional) is installed in the copier and is then withdrawn:
The INSERT KEY COPY COUNTER display appears
Copying is not possible
• If the counter is withdrawn during copying, the machine will stop after the paper being copied
has exited.
B-1) CLEAR PAPER (
• Leading-edge jam detection by the exit switch (S9): (E01)
The aligning motor is turned ON
The exit switch (S9) comes ON
* When the exit switch (S9) has not come
ON after 1.313 seconds have elapsed.
The CLEAR PAPER symbol (E01) ap-
pears and copying will stop.
4560/4570 OPERATION
)
Remove the paper from the sheet-bypass guide. The manual-feed switch
(S6) goes OFF .
)
1.313 sec.*
)
Aligning motor
Exit switch
Timer
4 - 8
On
On
0 1.313 sec
CLEAR PAPER (E01)
Nov. 1997 © TOSHIBA