User Guide
4.8 CPU and Heat Sink Module Replacement
Note: The CPU and Heat Sink module are not hot swappable. The enclosure must be powered-
down, disconnected from all cabling, and removed from the rack before replacing the CPU and
Heat Sink module.
Table 43: Procedure Info
Required Tools
•
T30 Torx Screwdriver
•
T15 Torx Screwdriver
Step 1 : Uncable the CMA(s).
a. Open all of the basket clips on the CMA(s).
b. Remove one cable at a time from the arm, making sure not to put too much strain on the
arm.
Step 2 : Remove the CMA(s).
Required Parts
•
T30 Torx screws
Figure 111: Open Baskets
4.8 CPU and Heat Sink Module Replacement
# of People Required Time Required
3
4. Part Replacement
~2h
114