Western Digital Ultrastar Serv60+8 User Manual page 188

User Guide
Step 6 : Follow the previous step for each drive in the enclosure. Attach a label or mark the drives with
the drive slot they were removed from in order to add them to the same slot in the future. Store
the drives in an ESD safe location until the drives are ready to be installed back into an enclosure.
Step 7 : Release the safety latch on the inner rails on each side of the chassis as shown in the following
image.
Step 8 : Grasp both handles at the front of the enclosure and pull with even pressure to extend the
chassis out of the rack until it is stopped by the safety latches. Make sure that the top cover
comes with the chassis as it is extended out of the rack. The safety latches will prevent the
enclosure from coming out of the rack completely.
Step 9 : Remove the chassis from the rack.
a. Be prepared to support the enclosure once it is free of the rails by having a second
person or a lift to support the enclosure
b. Grasp both handles at the front of the enclosure and pull with even pressure until the
enclosure will not extend further.
c. Locate the safety catches on the inner rails attached to the enclosure.
Figure 203: Inner Rail Safety Latch Release
4. Part Replacement
4.10 M.2 Replacement
179