Western Digital Ultrastar Serv60+8 User Manual page 308

User Guide
Step 52 : Install the CMA(s).
a. Orient the CMA so that the elbow is on the left hand side.
b. Attach all three of the connectors to the brackets on the rails. There should be one at the
elbow side and two at the other end.
c. Slowly slide the enclosure forward to ensure the arm is operating properly, then slide it
back into the rack.
a. CMA Standard: Repeat these steps to install the upper arm with the elbow facing to the
right.
Step 53 : Grasp both handles at the front of the enclosure and pull with even pressure to extend the
chassis out of the rack until it is stopped by the safety latches. The safety latches will prevent the
enclosure from coming out of the rack completely and the cover will remain in the rack attached
to the rear alignment brackets.
Note: Adjustments of the vertical rack rails may be required to fix any issues that
may occur.
Note: CMA has one arm, to be installed at the lower position. This arm should
have the elbow on the left side.
Figure 385: CMA Orientation
4. Part Replacement
4.14 Chassis Replacement
299