Western Digital Ultrastar Serv60+8 User Manual page 368

User Guide
b. Default Port Settings:
c. Default Optional Network Services:
Step 3 : Save the new settings.
A message notifying that the parameters of the security section have been set will appear.
• Failed Login Interval Time (sec): The value of 20 seconds between failed login
attempts is set by default. Input a different number of seconds to change the
amount of time between being locked out due to failed login attempts. The
number of failed login attempts is defined by the Failed Login Attempts field.
• Remote Client Lockout Time (sec): The value of 120 seconds of remote client
lockout time is set by default. If the user exceeds the number of failed login
attempts, it will lock remote access to the BMC Web GUI for the defined
amount of time. Input a different number of seconds to change the amount of
time between being locked out due to failed login attempts.
Figure 464: Port Settings
• HTTPS (Secure) Port The port settings are set to a default of 443. Input a
different number to change the specific port that is being connected.
Figure 465: Optional Network Services
• SMASH SSH: The checkbox is selected by default. Uncheck Enable to disable
SMASH SSH.
• SOL SSH: The checkbox is not selected by default. Check Enable to enable SOL
SSH.
• HTTPS: The checkbox is selected by default. Uncheck Enable to disable secure
web browsing.
• IPMI over LAN: The checkbox is selected by default. Uncheck Enable to disable
IPMI access over LAN.
5. System Management
5.4 BMC Web GUI
359