Western Digital Ultrastar Serv60+8 User Manual page 310

User Guide
e. When the IOM is lowered fully, apply light pressure with both hands evenly on the IOM
body, not the handles, to seat the IOM in the connector. If the IOM won't seat correctly,
DO NOT FORCE IT. Instead, back the IOM out, check the pins to make sure none are
damaged, and try again.
f. Once the IOM is seated properly in the slot, close the handles until they latch closed.
Step 55 : Install the drive blank in slot B using the same method as installing the IOM.
Step 56 : Install the System SSD.
a. Lift the center channel flap and orient the assembly so that the latch release button is
facing toward the rear of the system.
Figure 389: Lift the Center Channel Flap
Figure 388: Installing the IOM
4. Part Replacement
4.14 Chassis Replacement
301