Western Digital Ultrastar Serv60+8 User Manual page 262

User Guide
Step 23 : Secure the chassis top cover to the rack using the captive M5 thumb-screws as shown in the
following image. Use a T15 Torx screwdriver, and tighten the screws to 3.38-3.61 Nm / 30-32 in-
lbf.
Figure 310: Cover Retention Screws
Note: If any drives were removed earlier to facilitate the removal of the chassis, follow the
rest of the steps to reinstall the drives by following the labeling scheme noted earlier. If not,
proceed to the cabling section.
Step 24 : If the chassis is being installed into a rack that will be shipped fully assembled, you must install
eight (four per side) of the included M5 x 12mm T15 Flat Head Torx screws into the two brackets
at the front of the chassis in the following locations. These screws should be tightened to
3.38-3.61 Nm / 30-32 in-lbf using a Long T15 Torx Screwdriver. If this chassis will not be installed
into a rack for shipping purposes, skip this step and move on to the next one.
Figure 311: Shipping Bracket Screw Locations
4. Part Replacement
4.13 Rails Replacement
253