Western Digital Ultrastar Serv60+8 User Manual page 232

Hide thumbs Also See for Ultrastar Serv60+8:

Table of Contents

b. Slide the nut plate down over the mounting pin on the back of the spacer bracket.

c. Using a T15 Torx screwdriver, tighten the top captive screw to secure the mounting plate

in place. Then tighten the remaining captive screws at the bottom of the spacer bracket.

Torque all four of the captive screws to 3.38-3.61 Nm / 30-32 in-lbf.

d. Repeat these steps to install the remaining rack spacer.

Step 13 : Install the chassis into the rails.

Figure 266: Rack Spacer Nut Plate Installation

Figure 267: Captive Screws

4. Part Replacement

4.12 CMA Replacement