Western Digital Ultrastar Serv60+8 User Manual page 95

User Guide
Note: The DIMMs are not hot swappable. The enclosure must be powered-down,
disconnected from all cabling, and removed from the rack before replacing the DIMMs.
Table 42: Procedure Info
Required Tools
•
T7 Torx Screwdriver
Step 1 : Uncable the CMA(s).
a. Open all of the basket clips on the CMA(s).
b. Remove one cable at a time from the arm, making sure not to put too much strain on the
arm.
Step 2 : Remove the CMA(s).
a. Release all of the connectors that attach the CMA(s) to the enclosure and the rail.
b. To release a connector, press the blue latch release button and pull the connector free.
Required Parts
•
Figure 71: Open Baskets
There are three total connections that need to be released, one at the elbow and two
at the opposite end.
# of People Required Time Required
T7 Torx screws
4. Part Replacement
4.7 DIMM Replacement
3 45m
86