Western Digital Ultrastar Serv60+8 User Manual page 225

User Guide
b. Remove one cable from the CMA at a time making sure not to put too much strain on the
arm.
Step 5 : Unlatch all of the connectors that attach the CMA(s) to the enclosure and the rail by locating
the latch release button and pressing it from either side of the latch. There are three total
connections that need to be removed, one at the elbow and two at the opposite end.
Step 6 : Grasp both handles at the front of the enclosure and pull with even pressure to extend the
chassis out of the rack until it is stopped by the safety latches. The safety latches will prevent the
enclosure from coming out of the rack completely and the cover will remain in the rack attached
to the rear alignment brackets.
Figure 254: Open Baskets
Figure 255: Unlatching a CMA Connector
4. Part Replacement
4.12 CMA Replacement
216