Western Digital Ultrastar Serv60+8 User Manual page 84

Hide thumbs Also See for Ultrastar Serv60+8:

Table of Contents

Step 2 : Locate the faulty System Fan by the flashing amber LED near the rear of the drive bay and the

center channel that will be lit on top if there is a fault or by activating the identify LED on the

System Fan being replaced.

Step 3 : Remove the new System Fan from its packaging.

Step 4 : Uninstall the internal System Fan.

a. Lift the System Fan flap and insert a finger into the service hole on the top of the System

Fan and pull up to release the latch.

b. Use the handle to pull evenly on the component to remove it from the enclosure.

Figure 52: Lift the System Fan Flap

Figure 53: Unlatching System Fan

4. Part Replacement

4.4 System Fan Replacement