Removing The Uch.8 Connectors From The Rf Pic - Cisco cBR Series Hardware Installation Manual

Maintaining the Interface Cards in the Cisco cBR Chassis
Figure 140: Removing the Interface Card from the Slot
Step 4
Grasp the faceplate of the card with one hand and place your other hand under the card to support its weight, and remove
the card from its slot.
Step 5
Place the removed card in an antistatic bag.
Note If a line card blank is removed, it need not be placed in an antistatic bag.
Note Close the spring-loaded ejectors before placing it in the anti-static bag.
What to do next
•

Removing the UCH.8 Connectors from the RF PIC

Three UCH.8 connectors are connected to the RF Through PIC. To remove a PIC, the UCH.8 connectors
connected to the PIC must be removed first. This procedure is used only for RF Through PICs. The following
steps describe how to remove one UCH.8 connector. Repeat the procedure to remove all the three UCH.8
connectors.
Before you begin
• Attach an ESD-preventive wrist strap to your wrist and connect the other end to the grounding lug
Replace the Interface Line Card or install a line card blank
connected to the chassis.
Removing the UCH.8 Connectors from the RF PIC
(as required).
Cisco Converged Broadband Routers Hardware Installation Guide
217