Cisco cBR Series Hardware Installation Manual page 27

What is a Cisco cBR Series Converged Broadband Router
Table 12: Ports on the Supervisor PIC
Port
SFP+ ports
Timing ports
GPS port
DTI ports
CM/DTP port
NME ports
Console port
Auxiliary port
The Supervisor PIC has the following LEDs:
LED
PIC_STAT
INSI_ACT
REPLACE
SFP+
DTI Normal
DTI Fast
NME Lnk
Cisco cBR-8 Converged Cable Access Router Supervisor 160G
Description
The Supervisor PIC has eight Ten Gigabit Ethernet
SFP (SFP+) ports. These ports are used to connect it
to the switch or router. These ports provide backhaul
connection to the WAN network.
The Supervisor PIC has two timing ports, 1 PPS and
10 MHz ports, which are reserved for future use.
The Supervisor PIC has a GPS port, which is reserved
for future use.
The Supervisor PIC has two DTI ports. These ports
are used for connecting to DTI server as a reference
clock source.
The Supervisor PIC has a CM/DTP port, which is
reserved for future use.
The Supervisor PIC has two NME ports. These ports
are the Gigabit Ethernet management ports. One port
is used for network management and is used to
connect to a switch and the other port is reserved for
future use.
The Supervisor PIC has one RJ-45 console port. This
port is an asynchronous EIA/TIA-232 serial port used
to connect a terminal to the Supervisor PIC for local
administrative access.
The Supervisor PIC has one auxiliary port. This port
is used to connect a terminal server to the Supervisor
PIC for verifying the system status.
Description
Supervisor PIC status LED
iNSI active LED
Replace LED
SFP+ module and link status LED
DTI normal mode status LED
DTI fast mode status LED
NME module link status LED
Cisco Converged Broadband Routers Hardware Installation Guide
19