Cisco cBR Series Hardware Installation Manual page 66

Attaching the Chassis Rack-Mount Brackets
• Front Rack-Mount Bracket Installation—The chassis is shipped with the rack-mount brackets installed
• Middle Rack-Mount Bracket Installation—Install the mounting bracket in the middle of the chassis, so
To install the rack-mount brackets in the middle of the chassis, complete the following steps:
Before you begin
Required Tools and Equipment
• #2 Phillips torque screwdriver
Step 1 Remove the rack-mount brackets installed in the front of the chassis by unscrewing the M5 undercut flat-head screws
using a #2 Phillips torque screwdriver.
Step 2 Locate the threaded holes at the middle on the side of the chassis that align with the holes in the rack-mount bracket.
Step 3
Install the 10 M5 undercut flat-head screws to secure each rack-mounting bracket to the chassis.
Secure five screws on each end of the rack-mounting bracket.
Step 4
Repeat the steps 1, 2, and 3 on the other side of the chassis.
Figure 27: Installing Rack-Mount Bracket
1 Chassis
Cisco Converged Broadband Routers Hardware Installation Guide
58
in the front. Proceed to installation of the chassis in the
that you can recess the chassis in the rack or install the chassis in a two-post rack unit.
Note
If the chassis is mid-mounted, you cannot install the chassis installation handle.
rack.
3 Rack-Mount Bracket
Installing the Cisco cBR Chassis