Cisco cBR Series Hardware Installation Manual page 188

Monitoring the Supervisor 250G in the Cisco cBR Chassis Using LEDs
LED
RP ACT
FP STAT
FP ACT
INSI ACT
ALRM
RPLC
Table 40: Verifying the LEDs on the Supervisor PIC
LED
PIC_STAT
INSI_ACT
REPLACE
Cisco Converged Broadband Routers Hardware Installation Guide
180
Monitoring the Supervisor in the Cisco cBR Chassis
Status
Off
Green
Off
Green
Yellow
Off
Green
Off
Green
Off
Yellow
Off
White
Status
Off
Green
Yellow
Off
Green
Off
Green
Description
RP is not active.
RP is active.
FP has not booted.
FP is operational.
FP has detected a fault.
FP is not active.
FP is active.
iNSI is not enabled.
iNSI is enabled.
No alarm condition is detected.
Alarm condition is detected.
Supervisor Card does not need to
be replaced.
Supervisor Card needs to be
replaced.
Description
The Supervisor PIC is not powered
up.
The Supervisor PIC is functioning
normally.
The Supervisor PIC has a fault.
iNSI module is not enabled.
iNSI module is enabled.
The Supervisor PIC does not need
to be replaced.
The Supervisor PIC needs to be
replaced.