Cisco cBR Series Hardware Installation Manual page 91

Installing the Power System in the Cisco cBR Chassis
Figure 42: Installing the Power Module in the Chassis
Step 3
Move the handle up to lock the Power Module in the chassis.
Step 4 Tighten the screw using a 3/16" flat-blade screwdriver with a torque of 5-7 in-lb (0.56-0.79 Nm) to secure the Power
Module.
Step 5 Repeat Step 2, on page 82
Step 6
Position the front power entry bezel on the chassis. Insert and tighten the two screws using a 3/16" flat-blade torque
screwdriver with a torque of 5-7 in-lb (0.56-0.79 Nm) to secure the bezel.
What to do next
• For an AC-powered Cisco cBR chassis,
• If all the interfaces and other cables are connected,
• Verify that the input power LED on the Power Module illuminates green.
to Step 4, on page 83
For an DC-powered Cisco cBR chassis,
Installing the Power Module in the Cisco cBR Chassis
for each Power Module.
connect the AC power.
connect the DC power.
power up the Cisco cBR
Cisco Converged Broadband Routers Hardware Installation Guide
chassis.
83