Removing The Fpem From The Cisco Cbr Chassis - Cisco cBR Series Hardware Installation Manual

Maintaining the Power System in the Cisco cBR Chassis
Figure 119: Removing the Power Module
Step 5
Place the removed Power Module in an antistatic bag.
What to do next
•
• Position the front power entry bezel on the chassis. Insert and tighten the two screws using a 3/16"

Removing the FPEM from the Cisco cBR Chassis

Before you begin
• For an AC-powered Cisco cBR chassis,
Replace the Power Module
flat-blade torque screwdriver with a torque of 5-7 in-lb (0.56-0.79 Nm) to secure the bezel.
For an DC-powered Cisco cBR chassis,
(if required).
remove the AC power
remove the DC power
Cisco Converged Broadband Routers Hardware Installation Guide
Removing the FPEM from the Cisco cBR Chassis
connections.
connections.
193