Using The Auxiliary Port On The Supervisor Pic - Cisco cBR Series Hardware Installation Manual

Installing the Supervisor in the Cisco cBR Chassis
• No flow control
What to do next
•
•

Using the Auxiliary Port on the Supervisor PIC

The auxiliary port provides a connection for a terminal server to allow remote access to the router and its
command-line interface (CLI).
Before you begin
•
•
Required Tools and Equipment
• RJ-45 cable
• RJ-45-to-DB-9 adapter
• Terminal server
Step 1
Connect one end of the RJ-45 cable to the auxiliary port on the Supervisor PIC.
Figure 86: Auxiliary Port Connection on the Supervisor PIC
Step 2 Connect the other end of the RJ-45 cable to the RJ-45-to-DB-9 adapter.
Route the cable through the Supervisor PIC cable management bracket and chassis-mounted fiber/cable
routing guide.
Connect a terminal server to the auxiliary port
Install the Supervisor PIC.
Install the Supervisor Card.
(if required).
Cisco Converged Broadband Routers Hardware Installation Guide
Using the Auxiliary Port on the Supervisor PIC
123